| 15 Apr 2025 |
 ststefa | * Hey there! The nixos-infect works quite nicely, thanks again!
Now when I try to apply to the aarch64-linux node from my aarch64-darwin using colnema (using deployment.buildOnTarget), it will somehow not "activate the profile".
I don't quite get what that means :-/
I tried:
colmena apply --reboot --force-replace-unknown-profiles
I get:
failure) Unexpected active profile: Profile(StorePath("/nix/store/0pi9dwfl661k77k8zvacz1h7ikj2hlsi-nixos-system-arm-1-24.11.716947.26d499fc9f1d"))
Any ideas? Maybe this is a noob-trap?
If I run without "--reboot" then colmena will finish without errors, but none of my changes seems to get applied. | 16:58:29 |
 dish1892 | In reply to @ststefa:matrix.org
Hey there! The nixos-infect works quite nicely, thanks again!
Now when I try to apply to the aarch64-linux node from my aarch64-darwin using colnema (using deployment.buildOnTarget), it will somehow not "activate the profile".
I don't quite get what that means :-/
I tried:
colmena apply --reboot --force-replace-unknown-profiles
I get:
failure) Unexpected active profile: Profile(StorePath("/nix/store/0pi9dwfl661k77k8zvacz1h7ikj2hlsi-nixos-system-arm-1-24.11.716947.26d499fc9f1d"))
Any ideas? Maybe this is a noob-trap?
If I run without "--force-replace-unknown-profiles" then it will reboot, but none of my changes seems to get applied. Shouldn’t matter but try set the ”replace unknown profile” setting in the config instead | 18:13:00 |
| dish1892 | In reply to @gmacon:matrix.org
I proposed adding a reboot subcommand to colmena to see what people think about the idea. If you have thoughts, please share them here or on the issue. Thanks! If i understand it right you want to run pre-apply commands? | 18:15:33 |
| dish1892 | In reply to @ststefa:matrix.org
Hey there! The nixos-infect works quite nicely, thanks again!
Now when I try to apply to the aarch64-linux node from my aarch64-darwin using colnema (using deployment.buildOnTarget), it will somehow not "activate the profile".
I don't quite get what that means :-/
I tried:
colmena apply --reboot --force-replace-unknown-profiles
I get:
failure) Unexpected active profile: Profile(StorePath("/nix/store/0pi9dwfl661k77k8zvacz1h7ikj2hlsi-nixos-system-arm-1-24.11.716947.26d499fc9f1d"))
Any ideas? Maybe this is a noob-trap?
If I run without "--force-replace-unknown-profiles" then it will reboot, but none of my changes seems to get applied. * | 18:17:26 |
 gmacon | I don't think so... Did you have something specific in mind for a pre-apply command? | 18:17:43 |
| ststefa | My intention was just to configure the remote with some packages and settings. | 18:36:14 |
| ststefa | If I may, I could post my flake.nix | 18:36:29 |
