In reply to @raitobezarius:matrix.org
did anyone measured their board energy consumption?

Highest readout while compiling LLVM over an PoE-Splitter on my Switch on port 10 and idle on port 12 (on sdcard, no peripherals):

Local Port 	PD Class 	Power Used [W] 	Current Used [mA] 	Priority 	Port Status
10	4	6.673	132	High	PoE ON
12	4	4.839	96	High	PoE ON

In reply to @0x4a6f:matrix.org

Highest readout while compiling LLVM over an PoE-Splitter on my Switch on port 10 and idle on port 12 (on sdcard, no peripherals):

Local Port 	PD Class 	Power Used [W] 	Current Used [mA] 	Priority 	Port Status
10	4	6.673	132	High	PoE ON
12	4	4.839	96	High	PoE ON

https://github.com/starfive-tech/VisionFive2/releases/tag/VF2_v3.4.5

Please do not upgrade u-boot/spl for 8GB DDR VisionFive2 since CMA will not allocated successfully under Debian image 202306;
Ok

https://github.com/starfive-tech/VisionFive2/releases/tag/VF2_v3.4.5

Please do not upgrade u-boot/spl for 8GB DDR VisionFive2 since CMA will not allocated successfully under Debian image 202306;

Ok

[    5.648273] pci 0001:01:00.0: 4.000 Gb/s available PCIe bandwidth, limited by 5.0 GT/s PCIe x1 link at 0001:00:00.0 (capable of 31.504 Gb/s with 8.0 GT/s PCIe x4 link)
[    5.654890] starfive-dwmac 16040000.ethernet: Enable RX Mitigation via HW Watchdog Timer
[    5.674813] pci_bus 0001:01: busn_res: [bus 01-ff] end is updated to 01
[    5.675396] starfive-dwmac 16040000.ethernet: Enabled L3L4 Flow TC (entries=1)
[    5.683493] pci 0001:00:00.0: BAR 14: assigned [mem 0x38000000-0x380fffff]
[    5.690083] starfive-dwmac 16040000.ethernet: Enabled RFS Flow TC (entries=10)
[    5.697309] pci 0001:01:00.0: BAR 0: assigned [mem 0x38000000-0x38003fff 64bit]
[    5.704178] starfive-dwmac 16040000.ethernet: TSO feature enabled
[    5.711409] pci 0001:00:00.0: PCI bridge to [bus 01]
[    5.718704] starfive-dwmac 16040000.ethernet: Using 40/40 bits DMA host/device width
[    5.724801] pci 0001:00:00.0:   bridge window [mem 0x38000000-0x380fffff]
[    5.745104] pcieport 0001:00:00.0: PME: Signaling with IRQ 63
[    5.762376] starfive-dwmac 16030000.ethernet end0: renamed from eth0
[    5.766832] mmc_host mmc0: Bus speed (slot 0) = 204799999Hz (slot req 200000Hz, actual 199999HZ div = 512)
[    5.787949] starfive-dwmac 16040000.ethernet end1: renamed from eth1
[    5.791348] xhci_hcd 0000:01:00.0: xHCI Host Controller
[    5.801479] xhci_hcd 0000:01:00.0: new USB bus registered, assigned bus number 1
[    5.813901] xhci_hcd 0000:01:00.0: hcc params 0x002841eb hci version 0x100 quirks 0x0000040000000890
[    5.823193] mmc_host mmc1: Bus speed (slot 0) = 204799999Hz (slot req 200000Hz, actual 199999HZ div = 512)
[    5.828340] xhci_hcd 0000:01:00.0: xHCI Host Controller
[    5.838605] xhci_hcd 0000:01:00.0: new USB bus registered, assigned bus number 2
[    5.846216] xhci_hcd 0000:01:00.0: Host supports USB 3.0 SuperSpeed
[    5.854293] hub 1-0:1.0: USB hub found
[    5.858147] hub 1-0:1.0: 1 port detected
[    5.864676] hub 2-0:1.0: USB hub found
[    5.868504] hub 2-0:1.0: 4 ports detected
[    5.916417] nvme nvme0: pci function 0001:01:00.0
[    5.921223] nvme 0001:01:00.0: enabling device (0000 -> 0002)
[    6.190840] usb usb2-port2: over-current condition
[    6.194808] mmc_host mmc0: Bus speed (slot 0) = 204799999Hz (slot req 100000Hz, actual 99999HZ div = 1024)
[    6.250806] mmc_host mmc1: Bus speed (slot 0) = 204799999Hz (slot req 100000Hz, actual 99999HZ div = 1024)
[    6.410819] usb usb2-port4: over-current condition
[    6.416380] mmc0: Failed to initialize a non-removable card
[   13.246815] xhci_hcd 0000:01:00.0: Error while assigning device slot ID: Command Aborted
[   13.260537] xhci_hcd 0000:01:00.0: Max number of devices this xHCI host supports is 32.
[   13.268574] usb usb1-port1: couldn't allocate usb_device
[   16.095163] platform cpufreq-dt: deferred probe pending      
[   66.542814] nvme nvme0: I/O 12 QID 0 timeout, completion polled
Timed out for waiting the udev queue being empty.
kbd_mode: KDSKBMODE: Inappropriate ioctl for device
setfont: KDFONTOP: Inappropriate ioctl for device
starting device mapper and LVM...
waiting for device /dev/disk/by-label/NIXOS_ROOT to appear....[  127.982824] nvme nvme0: I/O 24 QID 0 timeout, completion polled
[  127.988842] nvme nvme0: Shutdown timeout set to 10 seconds
...................
Timed out waiting for device /dev/disk/by-label/NIXOS_ROOT, trying to mount anyway.
[  189.422823] nvme nvme0: I/O 16 QID 0 timeout, completion polled